Our superb wired and wire-free burglar alarm systems are class leading and ensure the continued safety and security of you, your family and your Wirral home. Peninsula's security systems are not available in local DIY stores and are the best available to us, and now you.
We can supply and install wired and state-of-the-art advanced wire-free domestic & residential security alarms at great rates.
We conduct a full service of your alarm system every year and will remind you after 11 months, arranging a convenient time to visit the premises to give the system the 'once-over'.
We'll conduct a full survey of the alarm and supply you with a report/certificate of service, allowing you to prove its serviceability. We can offer landlords or agents of multiple properties/HMOs a discount, provided that the systems can be serviced on the same day and are in the same geographical location.
Latest tamper and hack-proof Alarm System comprising;
Please note that additional accessories will be fitted for a small additional cost (plus the price of the accessory) if ordered with a full system.
EN50313 European Standards For Intruder Alarms Systems The British Standards 4737, 7042, and BS 6799 Wireless Systems have now been replaced by the new European Standards BSEN 50131 series.
European Standards are not retrospective, therefore systems which are currently installed to British Standards will continue to be maintained and updated to that standard.
The European Standards have been under development for some time, and not all of the standards are complete, but work on these standards continues. However, there is a suite of European Standards available to enable companies to install to. To enables this, the European Standards will include a document PD6662:2004. This is a Published Document (PD) and is used to call up parts of the current standards of British Standards where European Standards are still under development. As new parts of the European Standards are completed they will eventually replace those parts of thePD6662, which will eventually be phased out.
One of the most significant issues within the EN standards is evaluating the risk associated with the premises and determining a grade of system. This is because once the grade of a system is determined it will define the extent of the system, its signaling and tamper security.
One of the most important aspects of the EN 50131 requirements is the concept of a security grade. For each installation, the grade of system has to be chosen according to various factors. In the EN the grade is described in terms of the type of intruder and how much effort they put into the burglary.
This is difficult to say at the moment and opinion on this matter varies from country to country. The view in the UK tends to require grades that are higher than other countries (e.g. a shop in Belgium at grade 2 could be grade 3 in the UK). To a large degree, the choice of grade would be guided by insurance companies. A typical view could be:
The EN standard says that it is not necessary to use the same grade of component throughout an intruder system.
If the installation is a grade 2 then there is no problem using, for example, a grade 3 power supply.
If however, an installer fits a grade 2 component (such as a detector) in a system then that system is limited to grade 2 at best.
It is possible to have a defined part of a system at a higher grade so long as all associated parts are at the same (or higher) grade. For example, a system combining intruder and hold-up (PA) functionality could have a grade 4 hold-up system whilst the intruder parts were limited to a grade 3. But this example is only valid if the power supply, alarm transmission system and warning devices used by hold-up (PA) parts are all grade 4. This would still allow intruder parts such as PIR's to be grade 3. The system as a whole is, of course, only grade 3.